Text File Categories
This drug is probably the closest non-relative that
methamphetamine has. This procedure
will yield you white crystalline propylhexedrine
hydrochloride which is very easily put up your nose. Remember, do not - under any
circumstances - inject this drug into your veins.
It will, undoubtedly, kill you since it causes brain
aneurysms when injected . I am not saying that like some idiot would say
"don't inject heroin, it will undoubtedly kill you."
No. I am telling you that for an absolute fact, you will die if you inject this
drug.
Remember that you can
scale this process up, using as many inhalers as you would like. Just be sure you
adjust all quantities of chemicals you use accordingly
with how many inhalers are used. Also, don't scale it down. 6 inhalers contain 1.5
grams of propylhexedrine. 5 will contain 1.25 grams.
4 will contain 1 gram. 3 will contain 0.75 grams. Get it? Also, remember to always
wear gloves and goggles. Never be without them.
* 6 (Six) Benzadrex Inhalers(Amazon sell this for around $14 per 3pack or you can get them at CVS, ETC)
* Distilled Water(wal-Mart sells this for around $1)
* Muriatic Acid(Home Depot sells this for around $20)
* Lye (you can get this off the internet off of pool supply sites for around $20)
* Toluene(Hardware stores around $20)
* Coffee Filters
* Funnel (Normal funnel used for automotive oil changing)
* Glass Eyedropper (Pharmacy)
* Glass Casserole Dish
* Small Glass Containers (mason jars work great)
1.Open all of the propylhexedrine containers, collecting the 6 cottons, set them aside. In a small glass container, mix 20ml of distilled water with 10ml Muriatic acid. Cut the cottons into little pieces and soak them in the acid water, Squeeze them, push on them in the liquid, be sure to get all of the stuff out of them. You are milking the propylhexedrine from the cottons. The propylhexedrine is going into the liquid.
2. Place a coffee filter into the funnel, and filter the liquid three times,each time using a new filter. Collect the filtered
liquid in a new glass container. Now, using teaspoon measures, measure 1/8th of a teaspoon of lye, and pour the lye into the filtered liquid. Stir the liquid, if it does not stay cloudy, then carefully add tiny bits more lye until the liquid stays cloudy. Just don't add too much. Also, remember not to touch lye - you will receive chemical burns.
3.Transfer the liquid in a sealable glass bottle, and add 30ml of Toluene. Shake the bottle for about five
minutes or so. Set the bottle down, and observe two different liquid layers separating.
4.Using the eyedropper, suck up the top layer,which is the Toluene, which contains the propylhexedrine. Put the
liquid you sucked up from the eyedropper into a fresh bottle, and add 25ml of distilled water, and 5 drops of Muriatic acid. Shake the bottle for another five minutes. Put it down, and let the liquid layers separate again. Suck off the top layer, and discard it,leaving the bottom water layer with the propylhexedrine.
5.Transfer the liquid to the glass casserole dish, and put it over low heat. The water will begin to evaporate, leaving relatively pure propylhexedrine hydrochloride. You should expect back at least 1 gram. Scrap the residue off the dish and either smoke it in a meth pipe or cut it into lines and snort it like you would cocaine.
a strong dose will be around 250mg, but as with anything that you are trying for the first time start off small and go from there. It is possible to over dose and you could put your life at risk, also your shouldn't use this or any other stimulant if you have or have had heart related health problems
Latest Topics
vBulletin Message